EasyManuals Logo

EdgeStar TBC50S User Manual

EdgeStar TBC50S
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
EdgeStar Mini Kegerator 6
Non-pressurized Accessory Kit Part Descriptions
The following section describes the parts of the optional TBC50-ACC
Accessory Kit (sold separately) and their purposes.
1. Non-Pressurized Tap - Using a piercing tube, this tap is to be inserted
into a non-pressurized keg. Beer and CO
2
lines are located at the top. It is
good practice to wet the piercing tube to lubricate before tapping the mini-
keg. Once the mini-keg has been tapped, secure the tap assembly onto
the top of the mini-keg using the spring-loaded catch.
2. Cartridge Stand - Used to elevate the cartridge holder and regulator to
fit in the unit's side compartment.
3. Cleaning Bottle - Used with non-pressurized tap assembly and CO
2
to
flush out the beer lines with cleaning solution (see pg. 11). EdgeStar
recommends using the cleaning bottle that came with your mini-kegerator
to conserve CO
2
.
4. CO
2
Cartridge - 16g food grade CO
2
cartridges. This provides the
propellant necessary to pressurize your mini-keg. Do not use BB
gun/paintball CO
2
cartridges - These often have some oil mixed in with
the CO
2
.
5. Regulator - Used to increase/decrease the flow of CO
2
. Please
reference the chart on pg. 11 of your TBC50 manual for pressure
suggestions.
6. Rubber Ring - When tapping your non-pressurized keg, you will need
to insert the tap into this ring and then into the keg. This will prevent CO
2
from escaping the tap set up.
7. CO
2
Releaser - Used to depressurize kegs. (Note: You may not need
to depressurize certain kegs. Please follow keg instructions.)
8. CO
2
Adapter - Screws into cartridge holder and pierces cartridge.
Once the adapter is screwed in, do not unscrew until the CO
2
cartridge is
completely empty, otherwise it will leak out.
9. CO
2
Cartridge Holder - Holds CO
2
cartridge in place so that it can be
pierced by CO
2
adapter. The holder sits in the cartridge stand.
The accessory kit is not a toy. Keep out of the reach of
children. CO
2
Cartridges are under pressure. ANY MISUSE
MAY CAUSE SERIOUS INJURY. DO NOT over-tighten the CO
2
components. DO NOT discharge CO2 cartridges towards face
or body or place them near heat.
WARNING
2
1
3
4
5
6
7
8
9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EdgeStar TBC50S and is the answer not in the manual?

EdgeStar TBC50S Specifications

General IconGeneral
BrandEdgeStar
ModelTBC50S
CategoryKitchen Appliances
LanguageEnglish

Related product manuals