EdgeStar VBM91SS - Installing the Sealing Strips

12
Installing the Sealing Strips
To install the sealing strips:
1. Make sure the leveling legs are properly installed and that the unit is level.
2. Using two or more people, carefully place the commercial refrigerator on its back.
3. Remove a sealing strip from the packaging.
4. Place the sealing strip on the bottom of the unit around the leveling legs.
5.Makesurethatthesealingstripisfullyinstalledandushwiththebottomoftherefrigerator.
6. Repeat steps 3-5 for the remaining sealing strips.
7. Carefully return the refrigerator to its original upright position.
8. Using a carpenter’s level, ensure that the refrigerator is still level.
Warning: Use two or more people to move and install the commercial refrigerator. Failure
to do so can result in back or other injury.
!
Right /Left sealing strip
Front /Back sealing strip
Four (4) sealing strips have been included with the commercial refrigerator. Two (2) for the front/
back, and two (2) for the right/left. Once the sealing strips are fully installed they will create a
barrierbetweenthebottomofthecommercialrefrigeratorandtheoorthatwillhelpprevent
dirt, debris, and other contaminenets from getting under the refrigerator.
Note: The size of the sealing strips may vary. When installing the sealing strips, please
safely remove any excess material, with scissors or a similar cutting tool, so that the
sealing strips match the underside of the refrigerator.
Warning: Take care when removing the excess material from the sealing strips. Improper
use of a cutting tool can result in injury.
!