EdgeStar VBM91SS - Installing the Door Handle; Installing and Removing the Shelves

13
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to be
installed.
2. Carefully remove the two pre-installed decorative plugs from the front of the door.
3. Insert each Phillips head screw through the gasket side of the door until the screw passes
through the door.
4. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle
isushagainstthedoorframe.
5. Carefully press the door gasket into its original position.
To Install the Shelves:
1. Open the door completely.
2. Place the back of the shelf on the desired shelf track.
3. Slide the shelf into the commercial refrigerator until it reaches the plastic stopper.
4. Press down the plastic stoppers on both sides of the refrigerator simultaneously and slide the
shelf past the stoppers.
5. Fully insert the shelf into the unit.
To Remove the Shelves:
1. Open the door completely.
2. If necessary, make sure you remove all the contents on the shelf.
3. Press down the plastic stoppers on both sides of the refrigerator simultaneously and slide the
shelf past the stoppers.
4. Continue to pull the shelf forward until it is completely removed from the inner compartment.
To prevent damaging a door gasket, make sure to open the door all the way before pulling the
shelves out of their track.
Note: Some commercial refrigerators do not have decorative plugs installed.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to
the stainless steel door.
!
Installing and Removing the Shelves