2-4 SECTION 2: MAGNETOMETER SETUP
4. Save the SonarSerial.ini file
a. Select File then Save in Notepad or WordPad
5. Restart Sonar application by selecting the shortcut in the Remote Desktop screen:
The Topside DISCOVER software needs to be setup to allow the serial data to be set to the selected COM
port. To setup the topside running DISCOVER, see Figure 2-1 and the instructions below:
1. Open DISCOVER on the PC or Laptop.
Double-Click Sonar
Shortcut w/mouse
4125 MAGNETOMETER INTERFACE 0016510_REV_A
To Next Page
Loading...
