18
V-2. Hardware WPS
1. To support WPS, driver installation is a prerequisite. Please refer to section
III to install driver first.
2. On your Wi-Fi Router or AP, press the WPS
button for the correct time length to activate
WPS.
Please check the instructions of your Wi-Fi
Router or AP to activate WPS correctly.
3. On the USB adapter, immediately, activate the WPS function by pressing
and holding the “WPS” button for a short while.
4. The process takes a while to establish connection. Once it’s done, you can
access the Internet right away.
To Next Page
Loading...
Need help?
General