Edwards CDP

© Edwards Limited 2008. All rights reserved. Page i
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
A386-11-880 Issue E
Contents
Section Page
1 Introduction .......................................................................................1
1.1 Scope and definitions ................................................................................................... 1
1.2 Description ................................................................................................................ 1
1.3 Construction .............................................................................................................. 1
1.4 Principle of operation ................................................................................................... 1
2 Technical Data ....................................................................................3
2.1 Mechanical data .......................................................................................................... 3
2.2 Performance .............................................................................................................. 3
2.3 Operating and storage conditions ..................................................................................... 3
2.4 Construction materials .................................................................................................. 3
3 Installation .........................................................................................5
3.1 Safety ......................................................................................................................5
3.2 System requirements .................................................................................................... 5
3.3 Unpack and inspect ...................................................................................................... 6
3.4 Remove the old Exhaust-Silencer (if necessary) .................................................................... 6
3.5 Fit the new Exhaust-Silencer .......................................................................................... 9
3.5.1 Fit the new Exhaust-Silencer to a QDP, iQDP or CDP i, Ei or Si pump ........................................... 9
3.5.2 Fit the new Exhaust-Silencer to a CDP Ni pump ...................................................................10
3.6 Leak-test the installation ..............................................................................................14
4 Maintenance ..................................................................................... 15
4.1 Introduction .............................................................................................................15
4.1.1 Safety information ......................................................................................................15
4.1.2 Overheated fluorinated materials ....................................................................................15
4.2 Frequency of maintenance ............................................................................................15
4.3 Inspect and clean the Exhaust-Silencer .............................................................................16
5 Storage and Disposal ........................................................................... 17
5.1 Storage ...................................................................................................................17
5.2 Disposal ...................................................................................................................17
6 Spares and Accessories ........................................................................ 19
6.1 Introduction .............................................................................................................19
6.2 Spares .....................................................................................................................19
For return of equipment, complete the HS Forms at the end of this manual.
edwards JP 07/09