HD490 Smart Encoder
Copyright © 2000-2012 EEG Enterprises, Inc. 32
All Rights Reserved.
K/D specifies whether the article is to be Kept in memory or
Deleted once it exits the queue. The default setting is Delete.
O/H instructs the Encoder to either Output the article to the
appropriate channel queue immediately or to Hold it in memory for
future use. Immediate output is the default setting.
N/L specifies whether the message is to be placed Next in line or
Last in line when it is sent to an output queue. The default setting is
Last.
Example
Output Message <CTRL+A>1 Title [Channel] [Repeat] [K/D] [O/H] [N/L] <ENTER>
Places a previously stored message into the appropriate text channel
output queue. Any parameters that are not specified will retain the
values the message was last stored with. The character following
<CTRL+A> in the command is a one. If O/H is set to H, the message
will not be output, and this command can be used to change the
messages’ parameters.
: <CTRL+A>0 EEG_URL T2 3 D O N <ENTER>
EEG on the Web <ENTER>
<http://www.eeg.tv>[t:p][C510]<ENTER> <CTRL+C> will create a
two line message that displays and identifies a URL address. The use of
brackets, attributes, and checksum is per CEA-608B specification. The
message will be placed next in the T2 output queue, inserted 3 times,
and then deleted.
Remove Message from Queue <CTRL+A>4 Title [K/D] <ENTER>
Removes all instances of the specified message from the output queue.
If the last K/D parameter associated with the message is D, the message
will also be deleted from memory. If the message is being output as this
command is received, the current repetition will be allowed to finish.
Display Message Status <CTRL+A>9 [Channel] <ENTER>
Displays the names and settings of the messages currently associated
with the specified Channel. If the Channel parameter is omitted,
displays the names and setting of all saved messages.
To Next Page
Loading...
