NORMAFIX
8.4 Panels assembly
Position the first panel and fix it to the floor.
Then, position the second panel and connect it to the first by using M8x16H screws, M8
washers and M8H nuts and fix it to the floor. Do the same for the remaining cubicles.
It is necessary to place the side end panels at the end of the set of cells. They use 14 M6
screws, washers and riveted nuts (supplied as accessories) to attach each panel.
Note: The assembly should be done with the roof panel to access the bus and cable
compartment door removed.
8.5 Fastening the panels to the floor
Refer to the deployment plan of the panels where its configuration is set, the overall
dimensions and recommended points of attachment to the floor.
The panels are fixed to the ground by means of M12 screws (4 attachment points in the end
cells, and two diagonal fixing points in the others).
To Next Page
Loading...