Safety
5
Fire Safety
To avoid a fire or explosion, follow these instructions.
• Shut down all equipment immediately if you notice static sparking or arcing. Do not restart the
equipment until the cause has been identified and corrected.
• Do not smoke, weld, grind or use open flames where flammable materials are being used or
stored.
• Provide adequate ventilation to prevent dangerous concentrations of volatile particles or vapors.
Refer to local codes or your material MSDS for guidance.
• Do not disconnect live electrical circuits when working with flammable materials. Shut off
power at a disconnect switch first to prevent sparking.
• Know where emergency stop buttons, shutoff valves and fire extinguishers are located.
• Clean, maintain, test and repair equipment according to the instructions in your equipment
documentation.
• Use only replacement parts that are designed for use with original equipment. Contact your EFD
representative for parts information and advice.
Action in the Event of a Malfunction
If a system or any equipment in a system malfunctions, shut off the system immediately and perform
the following steps:
• Disconnect and lock out system electrical power.
• Identify the reason for the malfunction and correct it before restarting the system.
Disposal
Dispose of equipment and materials used in operation and servicing according to local and national
codes.
Part Name Toxic or Hazardous Substances and Elements
Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated
Chromium Biphenyls Diphenyl Ethers
(Pb) (Hg) (Cd) (Cr6) (PBB) (PBDE)
All brass fittings XO O O O O
O: Indicates that this toxic or hazardous substance contained in all the homogeneous materials for this
part, according to EIP-A, EIP-B, EIP-C is below the limit requirement in SJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in all the homogeneous materials for this
part, according to EIP-A, EIP-B, EIP-C is above the limit requirement in SJ/T11363-2006.
China RoHS Hazardous Material Declaration
To Next Page
Loading...
Need help?
General
