17 18
MONITOR SETUP FAQS
If I remove the batteries will I lose the information on the monitor?
The monitor has an internal memory, so if you need to change or remove the batteries
and the information stored on it will not be lost.
How do I reset the monitor (clear the stored data and start again)?
Press and hold the mode/set and history buttons simultaneously for two seconds.
How far does the device transmit?
The transmitter works up to around 230ft/40m within the home. The 433MHz range is
well suited for in-home use. This can cover three floors and is also ideal for buildings
where electricity meters are situated outside.
I have three dashes (- - -) showing on the monitor. What does this mean?
Move the monitor closer to the transmitter and press the link button. If the dashes
remain on the monitor this would indicate that the transmitter and receiver are not
communicating. Please contact our customer services to help solve the problem.
The backlight appears to work sometimes and then not others. Is it broken?
No. The backlight is on a timer to save battery life. The monitor should work at darker
periods during the day when any buttons are pressed. The LED backlight will be
activated from 18:00 to 6:00 hours.
For more information about the elite go to www.efergy.us
Historical consumption
information for days,
weeks and months in
kWh, $ and KgCO2
Push the history button to access daily, weekly, and monthly stored data. Use the backward
and forward buttons to scroll between dates and compare consumption data. Press mode/
set button to change information from kWh to costs and Co2 emissions.
HISTORY MODE
Average information in
days, weeks, or months
in kWh, $ and KgCO2
To Next Page
Loading...
Need help?
General
