5. Activation
17
Activation of DuoCartSwitch DCS1 at fuel connector #1
1. Select [DuoCartSwitch] to activate the DuoCartSwitch
at connector #1. Press [ok] to confirm your selection.
2. A confirmation is displayed.
3. In the menu „Fuel Cartridge“ new menu items occur.
Select the connected fuel cartridges at fuel cartridge
connector #1.1 and #1.2 an press [ok] to confirm your
selection.
Analogue to this procedure select fuel connector #2.
Default setting after acti
vation: Full M10 fuel cartridge.
Setup of fuel cartridge size
1. Select [M10 (X%) @ #1.1] or [M10 (X%) @ #1.2]
to change the fuel cartridge size.
2. Press [ok] to confirm your selection.
You can select the following actions in the fuel cartridge
submenu:
- Reset:
Resets the fuel cartridge after it has been replaced.
Percentage filling level is reset to 100 %.
- M5 / M10 / M28:
Changes the fuel cartridge type for the respective
connector.
Analogue the procedure for all other fuel connectors.
ADVICE: The percentage filling level shows the rest capacity
of the connected fuel cartridge. If the fuel cartridge size is
changed, the consumed methanol is transferred to the
percentage filling level of the new fuel cartridge.
Switch over to another fuel connector
To switch over to another fuel connector, select the menu
item “Fuel Cartridge” an inactivated connector.
Please select [Activation] in the appropriate submenu of
the fuel connectors and press [ok] to confirm your selection.
A confirmation of the selection is shown.
To Next Page
Loading...
General