6. INSTALLATION
6.1 TOOLS NEEDED
7. INSTALLATION INSTRUCTIONS
Before installation, the list below shows a few precautionary measures to prevent nuts and bolts from
getting corroded and seizing over time.
1. Reduction of friction:
• Make sure the thread surface is clean; no ash, dirt, etc.
• It is recommended to use wax or lubricant on the surface of bolts when installing.
2. Correct operation:
• When installing the screws, ensure they are perpendicular to the axis of the thread. Do
not tilt.
• During the tightening process the force must be uniform, and the tightening torque
should not exceed the specified safety torque value.
• Use a torque wrench whenever possible. Avoid using an electric drill. If using an electric
drill, keep the speed low.
• Avoid using at high-temperatures and refrain from fast rotations to prevent rapid
temperature increase that could cause locking and seizing from using an electric drill.
To Next Page
Loading...