3.10 Fan belt
Too loose a fan belt leads to overheating and insufficient
charging of the battery.
A) Check the belt tension by pressing the middle of the
fan belt with your finger. A properly tensioned fan
belt should deflect 7-9 mm (at a pressure of 10 kgf).
B) Inspect the fan belt for damage and wear.
Fan belt adjustment
Loosen the two bolts that hold the generator and
adjust them to achieve a correct tension.
Don't forget to retighten the nuts and bolts after
adjustment!
Warning!
KKeeeepp ffiinnggeerrss cclleeaarr ooff vveennttiillaattiinngg ffaann aanndd
ffaann bbeelltt..
3.11 Oil cooler
A) Remove the oil cooler screen - refer to paragraph
1.8.
B) Use compressed air to clean the oil cooler screen
and the oil cooler.
Warning!
AAllwwaayyss cclleeaann tthhee ooiill ccoooolleerr wwiitthh ccoommpprreess--
sseedd aaiirr bbeeffoorree wwaasshhiinngg tthhee EEgghhoollmm 22110000
wwiitthh cclleeaann wwaatteerr,, o
orr tthhee ccoooolleerr mmaayy
bbeeccoommee ccllooggggeedd wwiitthh ddiirrtt..
7-9 mm Fan belt Bolts
Oil cooler screen
29
3. SERVICE AND MAINTENANCE
To Next Page
Loading...