2.2 Starting, driving and stop-
ping
The following conditions must be fulfilled before
the engine can be started:
A) The control levers A, B, C and D must be in
position "0".
B) The towing handle must be locked - refer to
page 11.
C) The driver must be in the drivers seat.
D) Fully depress the brake pedal (1) and release the
parking brake (2.)
E) Set the throttle hand lever (3) in ¼ throttle position.
Warning!
FFoorr tthhee ssaakkee ooff tthhee hhyyddrraauulliicc ssyysstteemm iitt iiss
iimmppoorrttaanntt ttoo aallllooww tthhee mmaacchhiinnee ttoo wwaarrmm
uupp bbeeffoorree lleettttiinngg
tthhee eennggiinnee ooppeerraattee aatt
ffuullll RRPPMM..
F) Turn the key (4) until the pre-heater indicator (5) and
the other light indicators illuminate. When the
pre-heater indicator goes out, turn the key further to
start the engine.
G) Release the brake pedal (1).
H) The drive pedal (6) is now to be activated
Forwards drive -
press the pedal forwards.
Stopping - leave the pedal in middle position.
Reverse drive -
press the pedal backwards.
The speed control is stepless.
Warning!
TTuurrnn tthhee sstteeeerriinngg wwhheeeell ccaarreeffuullllyy
EEgghhoollmm 22110000 iiss aann aarrttiiccuullaatteedd mmaacchhiinnee
aanndd hhaass aa vveerryy sseennssiittiivvee sstte
eeerriinngg..
Lever A, B, C
Lever D
Towing handle is locked
Basic operation
15
2. INSTRUCTIONS FOR USE
Right side
Left side
2
1
4
6
7
5
3
To Next Page
Loading...