Egholm 2100 - Engine Maintenance

Hydraulic oil filter
A) Remove the oil filter (under the Egholm 2100)
to drain the tank.
B) Lubricate the sealing surface with oil.
C) Install new oil filter.
D) Fill the tank with approx. 15 l of Texaco Rando HDZ
46 oil. Check that the oil covers ¾ of the sight
glass.
3.5 Engine maintenance
Warning!
AAllwwaayyss ssttoopp tthhee eennggiinnee bbeeffoorree
cchheecckkiinngg tthhee ooiill lleevveell oorr cchhaannggiinngg tthhee
ooiill aanndd ooiill ffiilltteerr..
Check the engine oil:
A) Park the Egholm 2100 on level ground.
B) Check the oil level before starting the engine.
C) Remove the dipstick, wipe it clean and reinsert it
fully.
D) Remove the dipstick and now read the oil level to
make sure that there is enough oil in the engine.
E) There are two marks on the dipstick. The oil level
must be between the upper and lower marking.
F) If the oil level is below the lower marking, add oil.
G) Never overfill. Always keep the oil level correct.
Top up engine oil
A) Remove the filler cap.
B) Top up with 15W/40 oil until the oil level is
approx. 2.7 l.
C) Wait a few minutes for the oil to drain in the oil pan.
D) Recheck the oil level.
Hydraulic oil filter
Check the oil
Removing the oil cap
Filling engine oil
22
3. SERVICE AND MAINTENANCE