11
1
3
4
Operator’s Manual Park Ranger 2150 Hedge cutter Operator’s Manual Park Ranger 2150 Hedge cutter
2.1 Assembly / Disassembly -
continued
5. Lock the Hedge cutter in place with the locking
handle on the A-frame. (Picture 1)
Fit the hydraulic hoses to connectors B, C and D.
(Picture 2+3)
6. Pull out pin on each wheel support strut.
Raise support struts all the way and remount the
pins. (Picture 4)
7. Removal:
Follow the procedure for tting in reverse order.
To avoid accidents when detaching the Hedge
cutter,
always make sure the machine is on a level
and stable surface.
Put the protective caps on the snap couplings to
protect them from dirt.
Lock A-frame
Support strut up Pin
L
o
c
k
e
d
Operator’s manual
Fit the hydraulic hoses to connectors
B+C
Fit the hydraulic hose to connector D
To Next Page
Loading...