16
1
Operator’s Manual Park Ranger 2150 Hedge cutter
2.4 Setting trimmer position -
continued
Horizontal/vertical hedge trimming on the left
side
1. Activate Lever B until the cutting bar reaches
the required position.
2. To trim at higher horizontal/vertical positions:
Activate Lever C to raise the cutting arm to the
required height. Use Lever B to reposition the
cutting bar.
Tips!
Trim hedges and bushes from below, i.e. with
the cutting bar turned with the outer part down,
so that the skid just touches the ground. Start
trimming.
The cutting bar is then raised higher up the
hedge, so that the same section is trimmed all the
way to the top. (Picture 1)
Operating speed
Depending on the conditions, an operating speed
of 1–3 km/h is recommended.
Skid
Operator’s manual
To Next Page
Loading...