EGi MILLENIUM - Telephone Message Module Operation; Telephone Message Broadcast Duration; Assigning Phone Number to Zone; Assigning Phone Number to Group

34.
4 Enabling and disabling the password for
messages over the telephone
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is NOT
active, and there is NOT a pre-recorded message
player (1103) in the system but THERE IS a module
for sending messages over the telephone (1104):
T-PHONE PASSWORD
NO disables the password for messages over the
telephone.
1+ 2+ 3+ 4+ will turn on the led lamp next to
YES. If then we press
YES then the code 1234 has been
enabled as password for messages over the telephone.
he 4 bottom keys
; ; SETUP and act
here as numeric keys.
This password will have to be entered in the telephone
keyboard whenever the user tries to broadcast a message
over the telephone. This will be requested by means of a
set of commands recorded in the module 1104. The user
will listen to these commands in his telephone handset after
dialling the extension reserved for the Public Address system.
3 Assigning a telephone number to a group
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is NOT a pre-recorded
message player (1103) in the system but THERE
IS a module for sending messages over the
telephone (1104):
T-PHONE ASSIGN
ZONE
+ or – modifies the telephone number.
+ or – modifies the group number.
ASSIGN assigns the selected telephone
number to the desired group number.
2 Assigning a telephone number to a zone
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is NOT a pre-recorded
message player (1103) in the system but THERE
IS a module for sending messages over the
telephone (1104):
T-PHONE
ASSIGN
+ or – modifies the telephone number.
+ or – modifies the zone number.
ASSIGN assigns the selected telephone
number to the desired zone number.
1 Changing the length of the time while a message
over the telephone can be broadcast
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is NOT a pre-recorded
message player (1103) in the system but THERE
IS a module for sending messages over the
telephone (1104):
T-PHONE
+ or – modifies the maximum time length
while a message can be broadcast.
Control console. Operation of the module for sending messages over the telephone
1202
If the general access password is active the system will require us to introduce it every
time we try to operate this module (see point 2 of “Access restrictions”).