EGO HT2400E - Page 27

56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E 27
PROBLEM CAUSE SOLUTION
Excessive vibration or noise. 1. Dry or corroded blades. 1. Lubricate the blades,
following the section
“LUBRICATING THE BLADE”
found on page 24 in this
manual.
2. Blades or blade
support is bent.
2. Replace with a new blade or
support. Contact EGO service
center for blade or support
replacement service, found
on page 29.
3. Bent or damaged teeth. 3. Replace with a new blade.
Contact EGO service center
for blade replacement
service, found on page 29.
4. Loose blade bolts. 4. Tighten the blade bolts.
Using a wrench, turn the bolt
clockwise to tighten.