PROBLEM CAUSE SOLUTION
The mower does
not mulch properly
◾ Wet grass clippings are sticking to the underside of
the deck.
◾ Wait until the grass dries before
mowing.
◾ The mower is set to cut too much grass at once. ◾ Raise the deck to a higher cutting
height setting.
There is excessive
vibration
◾ The cutting blade is loose. ◾ Tighten the blade bolt.
◾ The cutting blade is unbalanced. ◾ Balance the blade following the
instructions.
◾ The cutting blade is bent. ◾ Replace the blade.
◾ The motor shaft is bent. ◾ Contact the service center.
The handle locking
clamps cannot be
closed in position.
◾ The side rails are not fully extended. ◾ Fully extend the side rails, then
lock the clamps.
To Next Page
Loading...
Need help?
General
