2556-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT5200L/ZT5200L-FC
CAUTION: The mower must be transported on the bottom frame at all times! Fork lift should never come in direct
contact with the mower! Doing so may cause damage.
WARNING: Do not use this product if any parts shown in Fig. 5 are already assembled to your product when you
unpack it. Parts shown in Fig. 5 are not assembled to the product by the manufacturer and require customer installation.
Use of a product that may have been improperly assembled could result in serious personal injury.
◾
Inspect the product carefully to make sure that no breakage or damage occurred during shipping.
◾
If any parts are damaged or missing, please contact EGO after sale service.
B. SEAT INSTALLATION
The mower incorporates a safety interlock system that will stop the
drive motors and deck motors when the operator is unseated for
any reason while the mower is operating. This is a safety feature
designed to prevent runaway or accidental entanglement.
1. Lay the seat on its side and insert the cable plug into the
socket on the bottom of the seat (Fig. 6). This connects the
safety interlock system.
2. Rotate the two arm rests to the horizontal positions. Place the
seat closely against the front of the suspension base. Align the
two mounting holes in the seat with the holes in suspension
base, and use the Allen key D to secure the seat to the
suspension base with the two socket-head screws B (Fig. 7).
3. Lift the adjustment lever slightly and pull the seat forward to
expose the two backside mounting holes in the steel rails of
the seat assembly (Fig. 7).
7
Seat Position
Adjustment
Lever
6
Plug
Cable
Socket
Suspension
Base
To Next Page
Loading...
Need help?
General
