56V LITHIUM-ION CORDLESS CHAIN SAW — CS1800/CS1800-FC24
1. Remove the battery pack from the chain saw.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the
oil tank.
3. Position the chain saw on its side on a rm, at surface, so that the oil-tank cap
is facing upwards. Rotate the oil-tank cap counterclockwise to remove it (Fig. 9).
4. Carefully pour the bar and chain oil into the oil tank. Be careful not to let the oil
spill from the opening. Fill to the bottom of the ll neck. Wipe off any excess oil.
5. Replace the cap, place the saw upright, and view the level through the oil-
inspection window. Oil should ll the window.
NOTICE:
◾
Use OREGON
®
bar and chain oil for best results. It is specially designed to provide
low friction and faster cuts.
◾
Never use oil or other lubricants not specically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and ll when the oil level falls below the minimum
mark. Never operate the chain saw if the oil is not visible.
◾
Do not use dirty, used, or otherwise contaminated oil. Damage may occur to the
bar or chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated;
this will prevent rust on the chain and bar as well as the inside drive sprocket.
◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
To Next Page
Loading...
Need help?
General
