56V LITHIUM-ION CORDLESS HEDGE TRIMMER28
PROBLEM CAUSE SOLUTION
Excessive vibration or noise. 1. Dry or corroded blades. 1. Lubricate the blades,
following the section
“LUBRICATING THE
BLADE” found on page 25
in this manual.
2. Blades or blade support
is bent.
2. Replace with a new blade
or support. Contact EGO
service center for blade
or support replacement
service, found on page 30.
3. Bent or damaged teeth. 3. Replace with a new blade.
Contact EGO service cen-
ter for blade replacement
service, found on page 30.
4. Loose blade bolts. 4. Tighten the blade bolts.
Using a 5/16" wrench,
turn the bolt clockwise
to tighten.
To Next Page
Loading...
Need help?
General
