56V LITHIUM-ION CORDLESS LINE TRIMMER 21
Tips for best trimming results (Fig. 12)
The correct angle for the cutting
attachment is parallel to the ground.
This line trimmer allows you to rest
the bump knob on the ground for
operating more comfortably.
Do not force the trimmer. Allow the
very tip of the line to do the cutting
(especially along walls). Cutting with
more than the tip will reduce cutting
efciency and may overload the
motor.
The cutting height is determined by the distance of the cutting line from the lawn
surface.
Grass over 200mm should be cut by working from top to the bottom in small
increments to avoid premature line wear or motor drag.
Slowly move the trimmer into and out of the area being cut, maintaining the
trimmer at the desired cutting height. This can be either a forward backward or
side-to-side motion. Cutting shorter lengths produces best results.
Trim only when grass and weeds are dry.
Wire and picket fences can cause extra line wear or breakage. Stone and brick
walls, curbs, and wood may wear lines rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can
easily be damaged by the lines.
12
Direction of
rotation
Dangerous
cutting area
Best cutting
area
To Next Page
Loading...
