56V LITHIUM-ION CORDLESS LINE TRIMMER 29
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Line trimmer
doesn’t work.
1. The battery pack is not
attached to the trimmer.
1. Attach the battery pack to the
trimmer.
2. No electrical contact between
the trimmer and battery.
2. Remove battery, check contacts
and reinstall the battery pack.
3. The battery pack is depleted. 3. Charge the battery pack.
4. The battery pack or
line
trimmer is too hot.
4. Allow the battery pack or trimmer
to cool until the temperature
drops below 67°C.
5. The lock-off lever and trigger
are not depressed
simultaneously.
5. Press down the lock-off lever and
hold it, then depress the trigger to
turn on the line trimmer.
6. The motor is overloaded. 6. Stop the trimmer, remove the
battery, and clean the cutting
attachment; restart the trimmer.
Cutting attachment
will not advance line
1. Cutting attachment is bound
with grass.
1. Stop the trimmer, remove the
battery, and clean the cutting
attachment.
2. Not enough line on spool. 2. Remove the battery and replace
the cutting line; follow the section
“LINE REPLACEMENT” in this
manual.
3. Cutting attachment is dirty. 3. Remove the battery and clean the
spool and spool base.
4. Line is tangled on spool. 4. Remove the battery and remove
the line from the spool and
rewind; follow the section “LINE
REPLACEMENT” in this manual.
5. Line is worn too short. 5. Remove the battery and pull the
lines while alternately pressing
down on and releasing the
bump knob.
Grass wraps around
cutting head and
motor housing
Cutting tall grass at ground level. Cut tall grass from the top down to
prevent wrapping.
To Next Page
Loading...
Need help?
General
