To Next Page

To Previous Page

operating position (Fig.10).

TO ATTACH/DETACH THEBATTERY PACK

CHARGE BEFORE FIRST USE.

NOTE: For best performance, we recommend use with two 5.0 Ah EGO 56V Arc-Lithium batteries or with two EGO

56V Arc-Lithium batteries of greater capacity. When not in use, 56V battery packs should be stored in an enclosed

area where the temperature will not drop below -4°F (-20°C). Optimal charging temperatures are between 41°F (5°C)

and 104°F (40°C).

WARNING: If any parts are broken or missing, do not attempt to attach the battery packs to the snow blower or

operate the snow blower until the broken or missing parts are replaced. Failure to do so could result in serious injury.

1. The battery cover is hinged. Raise the battery cover by lifting the front of the cover.

2. The snow blower is equipped with two battery compartments, which accommodate two battery packs at the

same time.

3. Align the grooves in the battery pack with the raised ribs in one of the battery compartments, and then insert the

battery pack into the compartment (Fig.11).

4. Push the battery pack until you hear a “click”. The battery-release button will spring up when the battery pack is

securely attached.

5. Attach the other battery pack into the other battery compartment in the same way.

6. To detach the battery pack, depress the battery-release button to release the battery pack, and then lift it out of

the compartment (Fig. 12).

7. Close the battery cover.

NOTICE: Make sure that the latch on the snow blower snaps into place and that the battery pack(s) are secured

Other manuals for EGO SNT2400

Questions and Answers:

Need help?

Do you have a question about the EGO SNT2400 and is the answer not in the manual?

General