EGO SNT2400 User Manual

Snow blower is
not starting.
▪ Battery charge is
low.
▪ The auger-switch
trigger is
not depressed at the
moment of the LED
indicator flashing
green.
▪ The auger is
frozen by snow or
ice.
▪ The battery is
overteated. The
LED indicator on the
battery flashes
orange or shines red
(see the section
“BATTERY HIGH-
TEMPERATURE
PROTECTION” in
this manual).
▪ Charge the
battery.
▪ Press the auger
switch trigger
when the LED
indicator blinks. If the
LED indicator stops
blinking, the snow
blower will not be
response to the
pressing of auger-
switch trigger.
▪ Remove the
battery pack(s)
firstly, use the
supplied chute clean
tool to clear the snow
or ice that obstructs
on the auger. Restart
the snow blower.
▪ Remove the
overheated battery
from the snow blower
and wait until the
battery pack cools
down to
approximately
152°F (67°C), then
reinstall the battery
and restart the snow
blower.
The motor is on
but the auger
does not turn
on.
▪ The shear pin is
broken.
▪ Replace the shear
pin following
the section
“REPLACING THE
SHEAR PIN” in this
manual.
The LED light
button is
insensitive to the
first pressing.
▪ The internal self-
checking
process causes a
slight delay in the
first keystroke
response.
▪ Press the LED
light button and
hold for 1 second.

EGO SNT2400 Specifications

General

Stage Type	Two-stage
Clearing Width	24 inches
Battery Voltage	56 V
Auger Material	Steel
Drive System	Self-Propelled
Speed Control	Variable Speed
Intake Height	20 inches
Throwing Distance	50 feet
Number of Batteries	2
Chute Control	Remote
Speed Settings	Variable
Headlights	LED
Chute Rotation	200 degrees