56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX450010
8. Remove the line trimmer guard by loosening the two
bolts with washers (Fig. E7).
9. Install the brush cutter guard (not included) with the
two bolts and washers from the line trimmer, the same
way as line trimmer guard (Fig. E8).
NOTICE: When the machine is equipped with the brush
cutter head, be carefully to choose the correct guard.
OPERATION
WARNING: Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING: Always wear eye protection, along with
hearing protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING: To prevent serious personal injury,
remove the battery pack from the machine before
servicing, cleaning, changing attachments or removing
material from the unit.
APPLICATIONS
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to
reach using a normal mower.
NOTICE: The machine is to be used only for its
prescribed purposes. Any other use is deemed to be a
case of misuse.
ATTACHING/DETACHING THE BATTERY
Use only with EGO’s battery packs and chargers
listed in Fig.A2.
Fully charge before first use.
To Attach (Fig. F1)
Align the battery ribs with the mounting slots in the
machine battery port and slide the battery pack until it
snaps into position.
To Detach (Fig. F2)
Depress the battery-release button and the battery pack
will disengage from the latch.
WARNING: Always be aware for the location of your
feet, children, or pets when pressing the battery-release
button. Serious injury could result in if the battery pack
falls. NEVER remove the battery pack at a high location.
MOUNTING THE SHOULDER STRAP AND HOLDING
THE MACHINE
Depress the carabiner to open it and attach it onto the
carrying eyelet (Fig. H1).
For safe and better operation, put on the shoulder strap
across the shoulder as Fig. H2. Adjust the shoulder strap
in a comfortable operating position. Hold the machine with
both hands: One hand on the rear handle and the other
hand on the loop handle. The trimmer head should be
parallel to the ground so that it easily contacts the material
to be cut without the operator having to bend over.
There are two ways to release the strap. Take it away from
your shoulder directly (Fig. H3) or press the hook of the
strap and take it apart from the carrying eyelet fixed on the
shaft (Fig. H4).
WARNING: The shoulder strap is also a quick
release mechanism in a hazardous situation. When
an emergency occurs, take it off from your shoulder
immediately, no matter what way the strap is in.
WARNING: When wearing the strap, no other
wearable should interfere with the release and removal
of the strap.
WARNING: You should not use the single-shoulder
strap and double-shoulder strap simultaneously.
STARTING/STOPPING THE MACHINE (Fig. J)
To Start
1. Move the lock-off lever forward and then press the
trigger switch to start.
2. Different pressure on the trigger results in variable
rotating speed of the cutting unit. Adjust the speed to
suit the task at hand.
NOTICE: The motor starts only when the lock-off lever is
moved forward and the trigger switch is depressed at the
same time.
To Stop
Move the machine away from the cutting area and release
the trigger switch to stop it.
To Next Page
Loading...
Need help?
General
