EGO STX4500 User Manual

56 VOLT LITHIUM-ION COMMERCIAL CORDLESS LINE TRIMMER — STX4500
15
Indicator Lights
Meaning
Battery-status
indicator
Solid green
Battery charge level of 20% to 100%
Flashing green
Battery charge level of 10% to 20%
Solid red
Battery charge level of less than 10%
Flashing red
The battery pack is nearly depleted and needs
to be charged immediately.
Solid orange
The battery pack is overheated. Cool the battery
pack until the temperature drops below 67°C.
See “Battery High-Temperature Protection”
below
Flashing red/
green alternately
The battery pack electronics error. Replace
the battery pack or contact EGO customer
service center. See “Battery Electronics Error
Protection” below.
Speed indicator
(the illustration
shows the high
speed)
Solid green
The machine is working properly.
Solid orange
The machine is overheated. Cool the machine until
the temperature drops below 80°C. See “Machine
High-Temperature Protection” below.
Flashing orange
The machine is overloaded. See “Machine
Overload Protection” below.
Battery High-Temperature Protection
If the battery temperature exceeds 70°C during operation, the temperature-protection circuit will immediately shut off
the machine to protect the battery pack from overheating damage. The battery-status indicator will glow solid orange.
Release the trigger and wait until the overheated battery cools down and the indicator turns green, then restart the
machine.
Battery Electronics Error Protection
When the battery pack electronics error occurs, the battery-status indictor will flash red/green alternately and the
machine will shut off in 3 seconds. Replace the battery pack or contact EGO customer service center.
Machine Overload Protection
This machine has built-in overload circuit protection. When the machine is overloaded, the motor will stop and the
speed indicator will flash orange. Remove the battery pack from the machine, then reattach the battery pack and restart
the machine. Decrease the load on the machine, avoid too long or oversize cutting line or cutting on the heavy/woody
shrubs.
Machine High-Temperature Protection
If the machine temperature exceeds 90°C during operation, the temperature-protection circuit will immediately shut off
the machine from overheating damage. The speed indicator will glow solid orange. Release the trigger and wait until the
overheated machine cools down and the speed indicator turns green, then restart the machine.

EGO STX4500 Specifications

General

Brand	EGO
Model	STX4500
Category	Trimmer
Language	English