Code mode. Similarly, install and put the new Alarm you wish to add to the system
into House Code mode (see “Installation and House Coding” section). As before,
allow sufficient time so that all Alarms are now house coded correctly (this can be
confirmed by counting the number of flashes on each Alarm). You can then exit
House Code mode manually or let it exit automatically after 30 minutes. (N.B. for
this feature to work all devices in the system must be RadioLINK+).
2. Monitoring
The Ei600MRF RadioLINK+ Module has the ability to “Monitor” the RF signal path
and strength. This is an enhanced self-monitoring function that recognises system
tampering or Alarm head removal. In monitoring mode each Alarm will check the
presence of its strongest received RF signal. If the signal is missing then the Alarm
will record a monitoring failure event. It will also signal the failure via a change in
the indicator light pattern.
For more information on using this feature, please visit www.eielectronics.com and
refer to the relevant section on the RadioLINK+ Monitoring feature.
3. Data Extraction
The Ei600MRF RadioLINK+ Module allows for the extraction of information from an
Ei Electronics Compatible Alarm, using an Ei Electronics download device. Once
the system has been set up, information can be accessed securely from within
or outside a property if access is an issue The event log can contain very useful
information about any recorded events in the history of the Alarm such as: Fire
Events, Alarm Head removals, Button Tests, and so on.
Event logs can be retrieved as many times as necessary.
8
To Next Page
Loading...
Need help?
General
