What to do if Einhell Royal REK 1840/1 chain becomes hot?
If the chain on your Einhell Royal Chainsaw is getting hot, the problem may be with the chain lubrication. First, check the oil level. If the oil level is adequate, check the chain lubrication.
Why Einhell Royal REK 1840/1 motor does not run?
If the motor on your Einhell Royal Chainsaw isn't running, it could be due to a few reasons. First, check the socket, cable, and plug to ensure they are properly connected and undamaged. If the cable is damaged, have it repaired by Customer Service; do not attempt to patch it with insulating tape. Also, check the chain brake; see sections 16 and 17 ‘Chain brake’ and ‘Releasing the chain brake.’ Damaged switches must be replaced by a Customer Service workshop.
What to do if Einhell Royal Chainsaw has poor cutting performance?
If your Einhell Royal Chainsaw has poor cutting performance, there are a few things to check: * Make sure the chain is sharp; if it is blunt, sharpen it. * Verify that the chain is fitted correctly. * Check the chain tension.
Why Einhell Royal REK 1840/1 Chainsaw chain does not move?
If the chain on your Einhell Royal Chainsaw isn't moving, the chain brake may be engaged. Check the chain brake and release it if necessary.
General| Power | 1800 W |
|---|---|
| Bar length | 40 cm |
| Chain speed | 13.5 m/s |
| Oil tank volume | 160 ml |
| Power source | Electric |
| Voltage | 230 V |
| Guide bar length | 40 cm |
| Chain pitch | 3/8" |
| Chain gauge | 1.3 mm |
| Oil tank capacity | 0.16 L |
To Next Page
