the saw first.
DO NOT ALLOW YOUR FAMILIARITY WITH
THE SAW TO TURN INTO CARELESSNESS. IT
TAKES ONLY FRACTIONS OF A SECOND FOR
CARELESSNESS TO RESULT IN SERIOUS
INJURIES.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw’s noise is measured in accordance with
DIN EN ISO 3744; 11/95, DIN EN 11201. The
machine may exceed 85 dB(A) at the workplace.
In this case, noise protection measures need to
be introduced for the user (ear-muffs).
Cutting Idling
Sound pressure level LPA 61.2 dB(A) 56.1 dB(A)
Sound power level LWA 71.2 dB(A) 66.1 dB(A)
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.“
5. Technical data
Asynchronous motor 230 V 50 Hz
Power rating 85 W
Idle speed n0 1440 rpm
Protection type IP 20
Stroke 18 mm
Standing area 400 x 210 mm
Tilting table 0° to +45° to the left
Table dimensions 364 x 200 mm
Blade length 127 mm
Throat depth 405 mm
Cutting height max. at 90° 50 mm
Cutting height max. at 45° 25 mm
Weight 18 kg
6. Before putting the machine into
operation
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine’s moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
GB
11
Anleitung DKS 405 06.11.2001 11:25 Uhr Seite 11
To Next Page
Loading...
Need help?
General