EINHELL GC-PC 1235 I User Manual

GB
- 32 -
9. Troubleshooting guide
Problem Probable cause Corrective Action
Unit won’t start or
starts but will not
run.
- Incorrect starting procedures.
- Too much fuel in the combustion
chamber following failed attempts
to start the saw.
- Incorrect carburetor mixture adjust-
ment setting.
- Fouled spark plug.
- Fuel fi lter plugged.
- Follow instructions in the User Ma-
nual.
- Wait about 30 minutes until the fuel
in the combustion chamber has
evaporated before trying again to
start the chainsaw.
- Have carburetor adjusted by an Au-
thorized Service Center.
- Clean / gap or replace plug.
- Replace fuel fi lter.
Unit starts, but engi-
ne has low power.
- Incorrect lever position on choke.
- Dirty air fi lter.
- Incorrect carburetor mixture adjust-
ment setting.
- Move the lever to the correct positi-
on.
- Remove, clean and reinstall fi lter.
- Have carburetor adjusted by an Au-
thorized Service Center.
Engine hesitates. - Incorrect carburetor mixture adjust-
ment setting.
- Have carburetor adjusted by an Au-
thorized Service Center.
No power under
load.
- Incorrectly gapped spark plug. - Clean / gap or replace plug.
Runs erratically. - Incorrect carburetor mixture adjust-
ment setting.
- Have carburetor adjusted by an Au-
thorized Service Center.
Smokes excessi-
vely.
- Incorrect fuel mixture. - Use properly mixed fuel (40:1 mix-
ture).
Poor performance
when operated
- Blunt chain
- Loose chain
- Sharpen or replace the chain
- Tension the chain
Engine dies - Empty petrol tank
- Fuel fi lter in the wrong position in
the tank
- Fill up the petrol tank
- Completely fi ll the petrol tank or or
re-position the fuel fi lter in the petrol
tank
Insuffi cient chain
lubrication
(the cutter rail and
chain get hot)
- Empty oil tank for the chain
- Oil lubrication openings moved
- Top up the oil tank for the chain
- Clean the oil entry hole/groove on
the guide rail.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_PC_1235_I_SPK1.indb 32Anl_GC_PC_1235_I_SPK1.indb 32 30.06.2016 15:13:4430.06.2016 15:13:44

EINHELL GC-PC 1235 I Specifications

General

Brand	EINHELL
Model	GC-PC 1235 I
Category	Chainsaw
Language	English