Why does my EINHELL GE-DP 18/25 Li switch off after briefly running?
The EINHELL Water Pump may switch off due to the motor circuit-breaker activating. This can happen if the water is excessively contaminated, in which case you should take out the battery and clean the equipment and the shaft. It can also occur if the water temperature is too high; ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL GE-DP 18/25 Li Water Pump does not pump?
If your EINHELL Water Pump isn't pumping, the intake sieve might be clogged; clean it with a water jet. Also, check the discharge hose for kinks and unkink it if necessary.
How to improve insufficient pumping rate of EINHELL GE-DP 18/25 Li Water Pump?
To address an insufficient pumping rate in your EINHELL Water Pump: * Clean the intake sieve. * If the performance is reduced due to heavily contaminated and abrasive water impurities, clean the equipment and replace any worn parts. * Check the battery performance and charge the battery if necessary.
Specific safety information regarding the use and handling of lithium-ion rechargeable batteries.
Diagram and identification of the main components and parts of the cordless dirty water pump.
Instructions on the intended applications and limitations for the dirty water pump.
Key technical specifications and performance data of the pump.
Steps and methods for installing the pump for operation.
Instructions on how to switch on, operate, and switch off the pump.
General| Brand | EINHELL |
|---|---|
| Model | GE-DP 18/25 Li |
| Category | Water Pump |
| Language | English |
To Next Page