What to do if EINHELL Water Pump motor fails to start up?
If the motor of your EINHELL Water Pump fails to start, there could be a couple of reasons. First, check that there is mains voltage. If voltage is present, the pump rotor may be blocked. If so, dismantle and clean the pump.
What to do if thermostat switches EINHELL GE-WW 1246 N FS off?
If the thermostat is switching your EINHELL Water Pump off, it could be due to the motor being overloaded. In this case, dismantle and clean the pump. Alternatively, excessive friction caused by foreign substances might be the issue. Prevent the intake of foreign substances by using a filter.
Why EINHELL GE-WW 1246 N FS Water Pump has no intake?
If your EINHELL Water Pump isn't drawing water, several factors could be at play: * The intake valve may not be submerged; ensure it is fully immersed in water. * The pump chamber might lack a water connection; fill water into the intake. * There could be air in the intake line; ensure the intake line is airtight. * The intake valve might be leaking; try cleaning it. * The strainer could be blocked; clean the strainer. * The maximum suction height might be exceeded; check the suction height.
Why EINHELL GE-WW 1246 N FS Water Pump inadequate delivery rate?
An inadequate delivery rate in your EINHELL Water Pump can stem from several causes: * The suction height may be too high; check and adjust it. * A dirty strainer can impede water flow; clean the strainer. * If the water level is falling rapidly, reposition the suction hose to a deeper level. * Contaminants might diminish pump performance; in this case, clean the pump and replace any worn parts.
General| Power | 1200 W |
|---|---|
| Max Delivery Rate | 4600 l/h |
| Max Suction Height | 8 m |
| Max. water temperature | 35 °C |
| Pressure switch | Yes |
| Suction connection | 1" |
| Pressure connection | 1" |
| Power cord | 1.5 m |
| Hose connection | 1" |
To Next Page