How to troubleshoot EINHELL Water Pump when the motor fails to start up?
If your EINHELL Water Pump motor fails to start, there are a couple of things you can check. First, make sure there is mains voltage. If voltage is not the issue, the pump rotor may be blocked. In this case, you should dismantle and clean the pump.
What to do if the thermostat switches my EINHELL GE-WW 1145 ECO Water Pump off?
If the thermostat switches your EINHELL Water Pump off, it may be due to motor overload. Try dismantling and cleaning the pump to resolve this. Another potential cause is excessive friction from foreign substances. To prevent this, ensure you filter the intake to keep out foreign substances.
What to do if my EINHELL GE-WW 1145 ECO Water Pump has no intake?
If your EINHELL Water Pump isn't drawing water, several factors could be at play. First, ensure the intake valve is fully submerged. Next, check that the pump chamber has a water connection and fill the intake with water if necessary. Also, verify the intake line is airtight to prevent air leaks. Clean the intake valve and strainer to remove any blockages. Finally, confirm that the suction height isn't exceeding the maximum limit.
Why is the delivery rate of my EINHELL GE-WW 1145 ECO Water Pump inadequate?
If your EINHELL Water Pump's delivery rate is inadequate, it could be due to several reasons. Check if the suction height is too high and adjust it accordingly. Clean the strainer to remove any dirt. If the water level is falling rapidly, place the suction hose at a deeper level. Contaminants can also diminish pump performance, so clean the pump and replace any worn parts.
General| Power | 1100 W |
|---|---|
| Max Flow Rate | 4500 l/h |
| Max Pressure | 4.5 bar |
| Suction Height | 8 m |
| Delivery Height | 45 m |
| Max Water Temperature | 35 °C |
| Power Cable | 1.5 m |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Suction Connection | 33.3 mm (R1 AG) |
| Pressure Connection | 33.3 mm (R1 AG) |
To Next Page