Why won't my EINHELL Water Pump motor start?
If the motor of your EINHELL Water Pump fails to start, there are a couple of potential reasons. First, check the mains voltage to ensure there's power. Second, the pump rotor might be blocked. If it is blocked, dismantle and clean the pump.
How to fix no intake on EINHELL GE-WW 5537 E?
If your EINHELL Water Pump has no intake, consider these possible causes: a dirty non-return valve (clean it), a pump chamber without a water connection (fill water into the intake), air in the intake line (ensure the intake line is airtight), or exceeding the maximum suction height (check the suction height).
What to do if thermostat switches EINHELL GE-WW 5537 E off?
If the thermostat is switching your EINHELL Water Pump off, it could be due to an overloaded motor. If that’s the case, dismantle and clean the pump. Another possibility is excessive friction caused by foreign substances. To prevent this, use a filter to prevent the intake of foreign substances.
What to do if my EINHELL Water Pump has an inadequate delivery rate?
If your EINHELL Water Pump's delivery rate is inadequate, several factors could be the cause. Check if the suction height is too high. Also, the coarse filter might be dirty and require cleaning. If the water level is falling rapidly, place the suction hose at a deeper level. Contaminants might diminish pump performance, so clean the pump and replace any worn parts.
What to do if my EINHELL Irrigation System motor fails to start up?
If the EINHELL Irrigation System's motor isn't starting, first ensure there's mains voltage. If voltage is present, the pump rotor may be blocked. In that case, dismantle and clean the pump to resolve the issue.
Why is the delivery rate inadequate in my EINHELL Irrigation System?
If your EINHELL Irrigation System has an inadequate delivery rate, check the suction height as it might be too high. Also, the coarse filter might be dirty and needs cleaning. If the water level is falling rapidly, place the suction hose at a deeper level. Contaminants might also diminish pump performance, so clean the pump and replace any worn parts.
What to do if my EINHELL Irrigation System has no intake?
If your EINHELL Irrigation System isn't taking in water, the non-return valve might be dirty and needs cleaning. Ensure the pump chamber has a water connection by filling water into the intake. Check that the intake line is airtight, and verify that the maximum suction height hasn't been exceeded.
Why does the thermostat switch off my EINHELL Irrigation System pump?
If the thermostat in your EINHELL Irrigation System is switching the pump off, it could be due to an overloaded motor. Dismantle and clean the pump. Also, high friction from foreign substances can cause this issue, so prevent their intake by using a filter.
Lists all the components included in the product packaging.
Details the intended applications and limitations for the equipment.
Provides specifications and performance data for the home waterworks.
Instructions and steps to prepare the equipment before initial use.
Procedures for routine maintenance and servicing of the equipment.
Steps for cleaning or replacing the coarse filter component.
General| Power | 550 W |
|---|---|
| Max Pressure | 3.7 bar |
| Suction Height | 8 m |
| Mains Supply | 230 V |
| Max Water Temperature | 35 °C |
| Cable Length | 1.5 m |
| Pressure Connection | 1 inch |
| Suction Connection | 1 inch |
| Hose Connection | 1 inch |
To Next Page