Why does my EINHELL Water Pump switch off after briefly running?
The EINHELL Water Pump may switch off due to the motor circuit-breaker activating. This can happen if the water is excessively contaminated, in which case you should take out the battery and clean the equipment and the shaft. It can also occur if the water temperature is too high; ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL Water Pump does not pump?
If your EINHELL Water Pump isn't pumping, the intake sieve might be clogged; clean it with a water jet. Also, check the discharge hose for kinks and unkink it if necessary.
How to improve insufficient pumping rate of EINHELL Water Pump?
To address an insufficient pumping rate in your EINHELL Water Pump: * Clean the intake sieve. * If the performance is reduced due to heavily contaminated and abrasive water impurities, clean the equipment and replace any worn parts. * Check the battery performance and charge the battery if necessary.
Identifies and describes the main components of the pump using figures.
Instructions on how to install the pump, either stationary or with a flexible hose.
Guidance on how to mount or position the battery box for use.
Instructions for inserting and securing the battery pack into the unit.
Steps for charging the battery pack using the provided charger.
Explanation of the LEDs indicating battery charge status.
Instructions for operating the pump in shallow water levels.
Instructions for operating the pump with dirty water.
Explains the pump's switch settings and its automatic dry-run protection feature.
Steps to dismantle and clean the pump's paddle wheel.
Information on maintenance requirements for the equipment.
Details on how to order spare parts, including necessary information.
General| Brand | EINHELL |
|---|---|
| Model | GE-DP 18/25 LL Li |
| Category | Water Pump |
| Language | English |
To Next Page