EINHELL GE-DP 900 Cut

Questions and Answers

M
Michael ChaseAug 7, 2025
Why does my EINHELL GE-DP 900 Cut switch off after briefly running?
- C
  Charles MercadoAug 7, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
A
Alan MillerAug 12, 2025
What to do if my EINHELL Water Pump does not cut out?
- D
  dthomasAug 13, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
N
Nathan HallAug 18, 2025
What to do if my EINHELL GE-DP 900 Cut does not start?
- T
  troy68Aug 19, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
T
Thomas GilbertAug 26, 2025
What to do if my EINHELL Water Pump does not pump water?
- A
  Anne WagnerAug 26, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
A
amywilcoxAug 30, 2025
Why EINHELL GE-DP 900 Cut has insufficient pumping rate?
- J
  John LeAug 31, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.

Summary

Safety Regulations

Explanation of Symbols

Explains the meaning of symbols used in the manual for risk reduction.

Proper Use

Technical Data

Before Starting the Equipment

Installation

Details on stationary installation with rigid or flexible pipe lines, and important notices.

Operation

Setting the Float Switch

Adjusting the ON/OFF switching point of the floating switch for proper operation.

Replacing the Power Cable

Cleaning, Maintenance, and Spare Parts

Disposal and Recycling

Storage

Troubleshooting Guide

Service Information

Wear Parts and Consumables

Lists parts subject to normal wear and tear or required as consumables.

Warranty Certificate

EINHELL GE-DP 900 Cut Specifications

General

Type	-
Proper use	Pond
Product color	Black, Red
Suitable for indoor use	No
Suitable for outdoor use	Yes
AC input voltage	220 - 240 V
Power source type	AC
AC input frequency	50 Hz
Maximum delivery height	11.5 m
Maximum input water temperature	35 °C
Package depth	320 mm
Package width	492 mm
Package height	300 mm
Package weight	15300 g
Quantity per pack	1 pc(s)
Cable length	10 m