EINHELL GE-DP 900 Cut User Manual

GB
- 18 -
11. Troubleshooting guide
Faults Cause Remedy
The equipment
does not start
- Power supply not connected
- Floating switch does trigger
- Check power supply
- Raise position of fl oating switch
The equipment
does not pump
- Intake sieve clogged
- Discharge hose kinked
- Clean intake sieve with water jet
- Unkink the hose
The equipment
does not cut out
- Floating switch cannot sink - Place equipment correctly on shaft
bottom
Insuffi cient pumping
rate
- Intake sieve clogged
- Performance reduced due to heavi-
ly contaminated and abrasive water
impurities
- Clean intake sieve
- Clean equipment and replace wear
parts
The equipment swit-
ches off after briefl y
running
- Motor circuit-breaker switches the
equipment off due to excessive wa-
ter contamination
- Water temperature too high; motor
circuit-breaker switches the equip-
ment off
- Unplug power plug and clean
equipment and shaft
- Ensure that maximum permissible
water temperature (35 °C) is not
exceeded
Anl_GE_DP_900_Cut_SPK13.indb 18 02.11.2021 14:20:55
www.sidirika.nikolaidi.gr

EINHELL GE-DP 900 Cut Specifications

General

Type	-
Proper use	Pond
Product color	Black, Red
Suitable for indoor use	No
Suitable for outdoor use	Yes
AC input voltage	220 - 240 V
Power source type	AC
AC input frequency	50 Hz
Maximum delivery height	11.5 m
Maximum input water temperature	35 °C
Package depth	320 mm
Package width	492 mm
Package height	300 mm
Package weight	15300 g
Quantity per pack	1 pc(s)
Cable length	10 m

Weight and Dimensions

Weight	12800 g