Why won't my EINHELL GE-WW 9041 E motor start?
If the motor of your EINHELL Water Pump fails to start, consider these potential causes: - Check that there is mains voltage, and if not, fix it. - The pump rotor may be blocked. If this is the case, dismantle and clean the pump.
How to improve the delivery rate of my EINHELL GE-WW 9041 E?
If your EINHELL Water Pump has an inadequate delivery rate, consider the following: - Check that the suction height is not too high. - Clean the strainer if it's dirty. - If the water level is falling rapidly, place the suction hose at a deeper level. - If the pump performance diminished by contaminants part, clean the pump and replace wearing.
What to do if the thermostat switches off my EINHELL GE-WW 9041 E?
If the thermostat is switching off your EINHELL Water Pump, it could be due to: - An overloaded motor: dismantle and clean the pump. - Excessive friction from foreign substances: prevent the intake of foreign substances by using a filter.
What to do if my EINHELL GE-WW 9041 E has no intake?
If your EINHELL Water Pump isn't intaking water, several factors could be at play: - Ensure the intake valve is fully immersed in water. - Verify the pump chamber has a water connection; if not, fill water into the intake. - Confirm the intake line is airtight. - Check and clean the intake valve for any leaks. - Clear any blockages from the strainer. - Make sure that the max suction height is not exceeded.
General| Power | 900 W |
|---|---|
| Max Flow Rate | 4100 L/h |
| Max Suction Height | 8 m |
| Max Water Temperature | 35 °C |
| Pressure Switch | Yes |
| Protection Class | IPX4 |
| Suction Connection | 33.3 mm (R1 AG) |
| Pressure Connection | 33.3 mm (R1 AG) |
| Power Cord | 1.5 m |
To Next Page