What to do if my EINHELL Water Pump does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL Water Pump switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL RG-DP 4525 Water Pump does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL Water Pump has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL RG-DP 4525 Water Pump does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
General| Power | 450 W |
|---|---|
| Max Immersion Depth | 7 m |
| Max Water Temperature | 35 °C |
| Mains Supply | 230 V |
| Voltage | 230 V |
| Frequency | 50 Hz |
To Next Page