EINHELL RG-SP 750 LL - User Manual

Questions and Answers

J
John RobertsAug 11, 2025
Why does my EINHELL RG-SP 750 LL switch off after briefly running?
- K
  Katrina BraunAug 11, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
D
Dr. Shawn Robertson MDAug 17, 2025
Why EINHELL RG-SP 750 LL Water Pump has insufficient pumping rate?
- D
  daviscarlosAug 17, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
R
Rachel EvansAug 22, 2025
What to do if my EINHELL Water Pump does not start?
- K
  Kayla MillerAug 22, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
K
karlajarvisAug 29, 2025
What to do if my EINHELL RG-SP 750 LL Water Pump does not pump water?
- B
  Bill AllenAug 29, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
L
Lauren MillerSep 4, 2025
What to do if my EINHELL RG-SP 750 LL does not cut out?
- B
  Brian AtkinsonSep 4, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.