EINHELL RT-SS 120 L User Manual

also observe the safety regulations, the assembly
instructions and the operating instructions to be found
in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be
informed about the machine’s potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine’s construction and
design:
Harmful emissions of wood dust when used in
closed rooms.
Contact with the blade in the uncovered cutting
zone.
Injuries (cuts) when changing the blade.
Crushed fingers.
Kickback.
Tilting of the workpiece due to inadequate
support.
Touching the blade.
Catapulting of pieces of timber and workpieces.
4. Technical data
Mains voltage 230 V ~ 50Hz
021/07 rewoP Watt
Operating mode S1/S2 5 min
Idle speed n
0
400-1600 min
-1
Protection type IP 20
51 ekortS mm
Base area 470 x 190 mm
Tilting range of table -45°/0°/45°
Size of table 420 x 270 mm
Length of saw blade 127 mm
Max. cutting length at 90° 50 mm
Max. cutting length at 45° 20 mm
81 thgieW kg
Wavelength of laser 650 nm
Laser output < 1 mW
Load factor:
A load factor of S2 5 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (120 W) for no longer than
the time stipulated on the specifications label (5
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Noise emission values
The noise emission values were measured in
accordance with EN 61029.
Functions
Sound pressure level L
pA
82.6 dB(A)
K
pA
3 ytniatrecnu dB
Sound power level L
WA
92.4 dB(A)
K
WA
3 ytniatrecnu dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
5. Before starting the equipment
5.1 Please note
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
5
GB
Anleitung_RT_SS_120_L_SPK1:_ 16.06.2011 9:27 Uhr Seite 10

EINHELL RT-SS 120 L Specifications

General

Brand	EINHELL
Model	RT-SS 120 L
Category	Saw
Language	English