Need help?Do you have a question about the EINHELL TC-TS 2025/2 U and is the answer not in the manual?
General| Idle speed | 5000 RPM |
|---|---|
| Cutting height @ 45° | 65 mm |
| Cutting height @ 90° | 85 mm |
| Input power | 1800 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Placement supported | Freestanding |
| Number of teeth | 24 |
Weight and Dimensions| Table depth | 583 mm |
|---|---|
| Table width | 563 mm |
| Blade diameter | 250 mm |
Essential safety advice regarding personal protection, hearing, breathing, and eye safety.
Reference to safety regulations and general warnings for safe operation.
Defines the correct and prescribed usage of the bench-type circular saw.
Highlights potential residual risks and hazards associated with the equipment.
Essential checks and preparations before connecting and operating the equipment.
Instructions for operating the power switch and setting the cutting depth.
Detailed guide on using the parallel stop and cross stop for cuts.
To Next Page
