To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TC-TS 2025/1 U and is the answer not in the manual?
General| Input power | 2000 W |
|---|---|
| AC input voltage | 220-240 V |
| AC input frequency | 50 Hz |
| Number of teeth | 24 |
| Idle speed (max) | 5000 RPM |
| Cutting depth (45º) | 65 mm |
| Cutting depth (90º) | 85 mm |
Weight and Dimensions| Depth | 719 mm |
|---|---|
| Width | 559 mm |
| Height | 333 mm |
| Weight | 18800 g |
| Package weight | 22500 g |
| Base plate depth | 487 mm |
| Base plate width | 640 mm |
| Height adjustment range | 0 - 85 mm |
General safety precautions for electric tools to prevent injury and damage.
Specific guidelines for operation, maintenance, and environmental impact.
Identifies and labels all parts of the bench-type circular saw with diagrams.
Lists all accessories and parts supplied with the equipment.
Defines the correct uses for the bench-type circular saw and prohibited uses.
Lists risks associated with the machine's construction and operation.
Details measured sound and vibration values according to EN 61029.
Outlines inherent risks even when using the tool correctly.
Steps and checks to perform before connecting the equipment to power.
Instructions for assembling the primary support structure of the saw.
Guidance on attaching the side extensions to the saw table.
Steps for installing and removing the safety guard for the saw blade.
Procedure for changing the table insert when worn or damaged.
Instructions on how to correctly position the safety splitter.
Detailed steps for mounting and changing the saw blade.
How to safely turn the saw on and off.
Method for setting the desired blade cutting depth.
How to use the parallel stop for longitudinal cuts and adjustments.
Instructions for using the cross stop for crosscuts and angle adjustments.
Procedure for tilting the saw blade to achieve angled cuts.
Detailed steps for performing rip cuts along the wood grain.
Guidance on using push sticks for cutting narrow workpieces.
Specific instructions for very narrow workpieces requiring a push block.
How to perform angled cuts using the parallel stop.
Steps for making cuts across the wood grain using the cross stop.
Instructions and safety warnings for replacing the damaged power cable.
How to clean safety devices, air vents, and the motor housing.
Guidance on checking and replacing carbon brushes if sparking occurs.
Information on internal parts requiring maintenance.
Details required for ordering replacement components.
Guidelines for disposing of the equipment and packaging responsibly.
Recommendations for storing the equipment and accessories safely.
