Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep these
operating instructions in a safe place so that the
information is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and the safety information as
well. We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety information.
1. Safety information
CAUTION
Read all the safety information and instructions.
Any errors made in following the safety information
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
Safety information on the laser
Important:
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from accidents
by taking the appropriate precautionary measures.
n Do not look directly into the laser beam with the
naked eye.
n Never look directly into the laser path.
n Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
n Caution: It is vital to follow the work procedures
described in these instructions. Using the
equipment in any other way may result in
hazardous exposure to laser radiation or
radioactive contamination.
n Never open the laser module.
Safety information on the batteries
Use of the batteries
n Ensure that the ON/OFF switch for the laser (35)
is set to its “0” position before you fit the batteries.
n Inserting the batteries when the laser is switched
on can cause accidents.
n If the equipment is not used correctly the
batteries may leak. Avoid contact with the battery
fluid. If you come into contact with battery fluid,
clean the affected body part with running water. If
you get battery fluid in your eyes, seek immediate
medical assistance.
n Leaked battery fluid can cause skin irritation and
acid burns.
n Never expose the batteries to excess heat such
as sunshine, fire or similar.
n Never recharge batteries that are not suitable for
recharging. There is a risk of explosion!
n Keep batteries away from children, do not short
circuit batteries or disassemble.
n Seek a doctor’s advice immediately if a battery is
swallowed.
n If necessary, clean the contacts on the battery
and equipment before inserting the batteries.
n Ensure that you insert the batteries the right way
round.
n Remove flat batteries immediately from the
equipment. There is an increased risk of leakage.
n Always change all batteries in one go.
n Insert only batteries of the same type, do not use
different types of batteries or used and new
batteries together.
n Make sure that the equipment is switched off after
use.
n Remove the batteries if the equipment is not used
over a longer period.
2. Layout
1. Saw bench
2. Saw blade guard
3. Extraction hose
4. Splitter
5. Saw blade
6. Table insert
7. Parallel stop
8. Hand wheel
9. Adjusting and locking grip
10. Base frame
11. ON/OFF switch
12. Chain bar
13. Cross stop
14. Bench width extension
15. Bench length extension
16. Extractor adapter
25
GB
To Next Page
Loading...
Need help?
General