AFTER SALES SUPPORT
1300 922 271
service.australia@einhell.com
MODEL NUMBER: BT-AC 400/50 , 09/12
10
Important! The condensation water from the pressure
vessel will contain residual oil. Dispose of the condensation
water in an environmentally compatible manner at the
appropriate collection point.
7.3 Safety valve (10)
The safety valve has been set for the highest permitted
pressure of the pressure vessel. It is prohibited to adjust the
safety valve or remove its seal.
7.4 Check the oil level at regular intervals
Place the compressor on a level and straight surface. The
oil level must be between the two marks MAX and MIN on
the oil level window (Fig. 11/Item 15). Changing the oil:
Recommended hydraulic oil: SAE 15W/40 or an alternative of
the same quality. It should be relled for the rst time after
100 hours of operation. Thereafter the oil should be drained
and relled after every 500 hours in service.
7.5 Changing the oil
Switch o the engine and pull the mains plug out of the
socket. After releasing any air pressure you can unscrew
the oil drainage screw (15) from the compressor pump. To
prevent the oil from running out in an uncontrolled manner,
hold a small metal chute under the opening and collect the
oil in a vessel. If the oil does not drain out completely, we
recommend tilting the compressor slightly.
Dispose of the old oil at a drop-o point for old oil.
When the oil has drained out, re-t the oil drainage screw
(15). Fill new oil through the oil ller opening until it comes
up to the required level. Then replace the oil sealing plug
(14).
7.6 Cleaning the intake lter (1)
The intake lter prevents dust and dirt being drawn in. It is
essential to clean this lter after at least every 300 hours in
service. A clogged intake lter will decrease the compressor’s
performance dramatically. Remove the lter from the
compressor and undo the thumb screw on the air lter.
You can then remove the lter from the two halves of the
plastic housing, tap it to remove the dirt, blast it down with
low-pressure compressed air (approx. 3 bar) and re-insert it.
(Fig. 12)
7.7 Storage
Important!
Pull the mains plug out of the socket and ventilate the
appliance and all connected pneumatic tools. Switch o
the compressor and make sure that it is secured in such a
way that it cannot be started up again by any unauthorised
person.
Important!
Store the compressor only in a dry location which is not
accessible to unauthorised persons.
Always store upright, never tilted!
7.8 Ordering replacement parts
Please quote the following data when ordering replacement
parts: (information can be found on the warranty certicate
of the product)
• Type of machine
• Model number of the machine
• Product number of the machine
8. DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and can
therefore be reused or recycled.
The unit and its accessories are made of various types of
material, such as metal and plastic. Defective components
must be disposed of as special waste as directed by your
local council.
To Next Page
Loading...
