EINHELL TC-RH 800 4F User Manual

GBGB
- 28 -
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualied electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualied electrician, or the
authorized after sales service.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council oces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
Never place any electric power tools in your household refuse.
Old electric and electronic equipment and old electric power tools have to be separated from other was-
te and disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
The owner of the electrical equipment must make sure that the equipment is properly disposed of if he
no longer wants to keep the equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_SA_TC_RH_800_4F_SPK8.indb 28Anl_SA_TC_RH_800_4F_SPK8.indb 28 31.05.2021 09:52:3731.05.2021 09:52:37

EINHELL TC-RH 800 4F Specifications

General

Reverse	-
Drilling	Yes
Chuck type	SDS Plus
Product color	Black, Red
Power protection features	Overload
Input power	800 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Idle speed (max)	4500 RPM
Rated speed (max)	930 RPM
Rated speed (min)	0 RPM
Impact energy (max)	2.6 J
Drilling diameter in concrete (max)	26 mm

Weight and Dimensions

Weight	3120 g
Package weight	4970 g