EINHELL TC-SB 305 U - User Manual

TC-SB 305 U
Art.-Nr.: 43.080.55 I.-Nr.: 11015
7
D Originalbetriebsanleitung
Bandsäge
GB Original operating instructions
Band Saw
F Mode d’emploi d’origine
Scie à ruban
I Istruzioni per l’uso originali
Sega a nastro
HR/ Originalne upute za uporabu
BIH Tračna pila
RS Originalna uputstva za upotrebu
Trakasta testera
NL Originele handleiding
Lintzaagmachine
E Manual de instrucciones original
Sierra de cinta sin fi n
P Manual de instruções original
Serra de fi ta
SLO Originalna navodila za uporabo
Tra čna žaga
Anl_TC_SB_305_U_SPK7.indb 1Anl_TC_SB_305_U_SPK7.indb 1 10.12.15 08:0010.12.15 08:00

EINHELL TC-SB 305 U Specifications

General

Input power	750 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Summary

Safety regulations

Layout and items supplied

Layout (Fig. 1;2)

Diagram illustrating the different parts and components of the bandsaw.

Items supplied

List of supplied items and instructions for checking completeness and reporting missing parts.

Proper use

Technical data

Sound and vibration

Details on sound pressure and power levels, and required hearing protection.

Residual risks

Identification of potential residual hazards associated with the equipment's design.

Before starting the equipment

Assembly

Assembling the base frame, fitting the machine to the base frame (Fig. 1 a, 1 e, 3 a-3 c)

Instructions for assembling the base frame and mounting the machine onto it.

Fitting the saw table (Fig. 4-5)

Steps for attaching and securing the saw table to the machine.

Tensioning the blade (Figure 1)

Procedure for correctly tensioning the saw blade for safe and effective use.

Adjusting the blade (FIG. 1 a, 2)

Guidance on adjusting the blade to ensure it runs correctly on the pulleys.

Setting the blade guide (Fig. 7 - 10)

Instructions for setting the blade guides and support bearings for optimal blade support.

Adjusting the upper guide pins (28)

Procedure for adjusting the upper guide pins to the correct gap with the blade.

Adjusting the blade speed (Fig. 10, 11)

Steps for changing the blade speed by adjusting the drive belt tension.

Adjusting the machine table (15) to 90° (12;13)

How to adjust the saw table to a precise 90-degree angle relative to the blade.

Changing the blade (Fig. 14)

Step-by-step guide for safely removing and installing a new saw blade.

Operation

Longitudinal cuts (Figure 20)

Guide on how to perform straight cuts along the grain of the wood.

Making angular cuts (Fig. 19)

Instructions for performing angled cuts by tilting the saw table.

Freehanded cuts (Figure 21)

Guide on making curved cuts and radii without using guides.

Transport

Cleaning, maintenance and ordering of spare parts

Cleaning

Procedures for cleaning the bandsaw, including safety precautions.

Maintenance

Information regarding routine maintenance requirements for the equipment.

Ordering replacement parts:

Details on how to order spare parts, including required information.

Service information

Warranty certificate